Search
Filters

SERVICE - Custom Mopar Custom Evaporator/Heater Plenum Rebuild (fiberglass housing)

$525 plus s/h. Heater coil and seals sold separately. Parts and repairs, if needed, are additional.
SKU: 17-MPLF-dg
Make: DODGE
Call for availability
This service includes complete dismantling of your original fiberglass evaporator/heater plenum unit. All parts are stripped, glass beaded and repainted or zinc-plated, case halves are restored to original finish, evaporator is reconditioned, all vacuum actuators and switches are cleaned and tested. The unit comes back to you restored and ready to install. Note 1 - New foam seals and heater coil are additional and highly recommended. Note 2- Parts and/or fiberglass repairs, if needed, are additional.
This service includes complete dismantling of your original fiberglass evaporator/heater plenum unit. All parts are stripped, glass beaded and repainted or zinc-plated, case halves are restored to original finish, evaporator is reconditioned, all vacuum actuators and switches are cleaned and tested. The unit comes back to you restored and ready to install. Note 1 - New foam seals and heater coil are additional and highly recommended. Note 2- Parts and/or fiberglass repairs, if needed, are additional.
Products specifications
Model CHALLENGER
Model CHARGER
Model CORONET
Model DAKOTA
Model DART
Model DEMON
Model MONACO
Model POLARA
Model SUPER BEE
Years 62
Years 63
Years 64
Years 65
Years 66
Years 67
Years 68
Years 69
Years 70
Years 71
Years 72
Years 73
Years 74
Years 75
Years 76
Category SERVICES
Category EVAPORATOR UNIT PARTS
Category HEATER PARTS
Manufacturer DODGE

CONVERTING MOPARS TO 134a

Until 1995, most cars with air conditioning used R-12 Freon refrigerant that is said to have a negative side effect of damaging the ozone layer and is no longer produced in most countries. since then, the industry standard has been R134a, which is an efficient replacement.  Contrary to popular belief, most cars originally equipped with R-12 can be converted to 134a and still keep you just as cool.

1962 & Newer Systems - Minimum Requirements

  • Change or restore the filter-drier.

  • Drain the compressor oil and recharge with 134a compatible oil. (PAG or Ester Oil)

  • Insure that the system is clean and free of contaminants (Depending on component condition, this may be a simple matter of blowing out with compressed air or liquid flushing with an air-conditioning flushing agent)

  • Replace or restore all rubber hoses with barrier hose.

  • Remove EPR valve from compressor’s suction port

  • Install thermostat.

  • Charge with 134a between 70-80% of the original R12 charge amount.

  • Replace any o-rings with 134a compatible.

HELPFUL HINTS

  • Ignore the sight-glass. A properly charged 134a system will likely show bubbles in the sight-glass.

  • Typical 134a charge rate will be approximately 70-80% of the factory R12 charge amount.

Products specifications
Model CHALLENGER
Model CHARGER
Model CORONET
Model DAKOTA
Model DART
Model DEMON
Model MONACO
Model POLARA
Model SUPER BEE
Years 62
Years 63
Years 64
Years 65
Years 66
Years 67
Years 68
Years 69
Years 70
Years 71
Years 72
Years 73
Years 74
Years 75
Years 76
Category SERVICES
Category EVAPORATOR UNIT PARTS
Category HEATER PARTS
Manufacturer DODGE
Product tags