This service includes complete dismantling of your original fiberglass evaporator/heater plenum unit. All parts are stripped, glass beaded and repainted or zinc-plated, case halves are restored to original finish, evaporator is reconditioned, all vacuum actuators and switches are cleaned and tested. The unit comes back to you restored and ready to install. Note 1 - New foam seals and heater coil are additional and highly recommended. Note 2- Parts and/or fiberglass repairs, if needed, are additional.
CONVERTING MOPARS TO 134a
Until 1995, most cars with air conditioning used R-12 Freon refrigerant that is said to have a negative side effect of damaging the ozone layer and is no longer produced in most countries. since then, the industry standard has been R134a, which is an efficient replacement. Contrary to popular belief, most cars originally equipped with R-12 can be converted to 134a and still keep you just as cool.
1962 & Newer Systems - Minimum Requirements
Change or restore the filter-drier.
Drain the compressor oil and recharge with 134a compatible oil. (PAG or Ester Oil)
Insure that the system is clean and free of contaminants (Depending on component condition, this may be a simple matter of blowing out with compressed air or liquid flushing with an air-conditioning flushing agent)
Replace or restore all rubber hoses with barrier hose.
Remove EPR valve from compressor’s suction port
Charge with 134a between 70-80% of the original R12 charge amount.
- Replace any o-rings with 134a compatible.