This is the correct suction and discharge compressor service valve set used on most 1969 Ford, Mercury & Lincoln products equipped with factory a/c using a York or Tecumseh compressor with Roto-Loc head that uses a square-cut Teflon seal. O-rings are also used at hose connections. IMPORTANT NOTE - This set comes with 1 valve that is for the #8 (Discharge) hose and 1 valve that is for the #10 (Suction) hose and 2 Roto-Loc Teflon Seals. Please double check your current valves and compressor for size (#8 and #10) and type (O-Ring and Roto-Loc).
CONVERTING MY FORD TO 134a
Until 1995, most cars with air conditioning used R-12 Freon refrigerant that is said to have a negative side effect of damaging the ozone layer and is no longer produced in most countries. since then, the industry standard has been R134a, which is an efficient replacement. Contrary to popular belief, most cars originally equipped with R-12 can be converted to 134a and still keep you just as cool.
Systems w/o Suction Valve Minimum Requirements
Systems w/POA Valve (aka Suction Throttling Valve & By-Pass Valve) The POA Valve is installed on the evaporator, near the firewall. (Click here for a typical photo)
Systems w/Accumulator The accumulator is most often installed on the evaporator, near the firewall, but occasionally found in the middle of the suction hose between the evaporator and the compressor. (Click here for a typical photo)